Ring Size Chart
How to Measure a Man's Finger for Ring Size:
Get Sized at a Jeweler: To ensure the most accurate ring size, we recommend you
visit your local jeweler for a professional sizing.
Measure using an existing ring: Borrow one of your partner's rings and slide it down a
tapered candle. Measure the circumference of the candle where the ring stops.
Use those measurements and the chart below to determine the correct ring
size.
Printable Ring Sizer: Follow the directions below and use our printable ring sizer.
Additional Information on sizing:
Do comfort ring sizes run differently? Comfort fit rings tend
to fit looser than standard fit rings of the
same size. As a general rule of thumb, when purchasing a comfort fit
ring, you should choose a size that is about a
half size smaller than your standard fit ring size. All sizing
you perform from this page is considered standard ring sizes not comfort fit.
What is the Average Men’s Ring Size? Normally ranging from 8 to 14. Sizes 8 – 12 are
among the most often purchased. The average for men is 10.
Ring Size Conversion Chart
In order
to print the ring sizer above, be sure that your printer is set to 100%. Make
sure that you have not reduced the print size in your printer 'page setup'
area. You can verify that the sizer printed correctly by measuring it with a
ruler; it should measure from A to B: 3 1/2 inches long.
Once you have
printed the sizer, follow these directions to find your ring size:
1.
Cut
out the ring sizer
2.
Cut
a slit for Slot "A"
3.
With
the numbers facing out, wrap the sizer around the finger on where the ring will
be worn.
4.
Pull
the pointed end Tab "B" through Slot "A" until the sizer is
very snug.
5.
Measure
your knuckle the same way following the previous steps.
6.
The
larger of the two numbers aligned with Slot "B" is your ring size.